Yale HSA3000 Spezifikationen PDF herunterladen (Seite 7)

Mounting the door/window contact

Frame

Door/Window

Gap no more

than 10mm

Magnet

Sensor

ale

1 Find a location where the door/window contact

is to be mounted. It should be mounted between

the door/window frame and the door/window as

shown at the top of the opening. The magnet is to

go on the door/window while the sensor is to be

placed on the frame. Windows can be protected

in a similar way to doors. Make sure the tamper

switch spring is fully depressed.

-Mounting using adhesive pads

1 Clean the mounting surface with a suitable

degreaser agent.

2 Remove the protective ﬁlm from one side of the

adhesive pad and apply to the back of the sensor

and magnet

3 Remove the remaining protective ﬁlm and ﬁrmly

press into place.

4 Test sensor by pressing the test button and

opening and closing the door/window. The LED

should light when the door/window is opened.

Installation is complete.

-Mounting using screws and wall plugs

1 Loosen the bottom screw

and open the door/

window contact.

2 Knock out the holes on the

base as shown.

3 Drill holes into the

mounting surface using

the holes in the knockouts

on the base as template.

4 Fit wall plugs (if required) and secure with the

screws provided.

5 Fit sensor back together and tighten screw.

6 Test sensor by pressing the test button and

opening and closing the door/window. The LED

should light when the door/window is opened.

Installation is complete.

Mounting the Help button

1 Break through the knockouts (where the plastic is

thinner).

2 Using the holes as a template, drill holes in the

surface and insert wall plugs if ﬁxing into plaster or

brick. Screw the rear case to the wall.

3 Replace the cover and tighten the screw.

Mounting the Smoke Detector

1 The base has two mounting slots. Using the slots

as a template, drill holes and insert the wall plugs if

ﬁxing to plaster. Screw the rear case to the ceiling

using the screws provided.

2 Replace the cover.

The gap between the magnet and sensor should

be approximately 10mm when closed (depending

upon the actual environment).

Simple test to see whether the magnet is in range

of the sensor: hold the magnet and sensor in

place and then pull them apart. If the sensor LED

lights up it implies the two items are within range.

Knockouts

The tamper switch will automatically reactivate

after 3 hours (after initial Siren power switch On).

Alternatively you can enable the tamper switch

manually by disarming using your keypad (Disarm

& pincode: default 0000).

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Yale HSA3000 Spezifikationen Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Yale HSA3000